Preventative maintenance by fully licensed technicians is strongly recommended annually for all heating systems. Our Secure Heat Service Plan seeks four operational objectives:

  • Safety — Always first, your system should give you peace of mind.
  • Efficiency — Energy is too expensive to have a system at less than maximum output.
  • Longevity — Routine care preserves your heating system investment for the long haul.
  • Savings — A tuned heating system pays you back with lower energy bills.

With Secure Heat, you get:

  • Our 13 Point Tune-Up.
  • Service throughout the year.
  • Emergency attention for no heat anytime day or night.
  • Tanksure Oil Tank Inspection
  • $1,000 Replacement Credit

Plus, repair or replacement of covered parts that fail during regular use at no additional cost.

13 Point Tune-Up

  1. Clean or replace Oil Filter.
  2. Clean or Replace Air Filter.
  3. Clean or replace Oil Strainer.
  4. Clean Nozzle Assembly and replace Nozzle, if needed.
  5. Lubricate Motors.
  6. Lubricate Bearing Assembly.
  7. Inspect and vacuum Smoke Pipe.
  8. Inspect and vacuum Boiler or Furnace.
  9. Test Safety Timing of all Controls.
  10. Seal air leaks around the combustion chamber and venting.
  11. Perform combustion efficiency test with Bacharach Kit.
  12. Visually inspect the wiring.
  13. Visually inspect the Oil Tank.

Water Heating System

$329 – Covers all boiler systems using hot water.

Warm Air Heating System

$299 – Covers all furnace systems using hot air.

Oil Fired Hot Water

$179 – Covers domestic water heaters.

Covered Parts

Water Heating System – $329

  • Aquastat
  • Automatic Air Vent
  • Back Flow Valve
  • Blast Tube
  • Boiler Drain
  • Burner Coupling
  • Burner Fan
  • Burner Head
  • Burner Ignitors
  • Burner Motor (up to 1/7 hp)
  • Cad Cell Assy
  • Circulator and Associated Parts (1)
  • Circulator Relay (1)
  • Combustion Chamber
  • Delay Oil Valve and Timer
  • Draft Regulator
  • Electrodes
  • Emergency/Service Switches
  • End Cone
  • Expansion Tank (Boiler)
  • Firomatic Valve
  • Burner Gaskets
  • Flo Check (1)
  • Fuel Pump
  • Gasket
  • Tridacator Guage
  • Limit Controls
  • Low Water Cut-off
  • Mixing Valves (Domestic Only)
  • Nozzle
  • Nozzle Assy
  • Nozzle Line
  • Oil Filter (Cartridge)
  • Oil Filter (Complete)
  • Pressure Reducing Valve
  • Pressuretrol (Steam)
  • Primary Control
  • Pump Strainer
  • Relief Valves (Boiler & Domestic)
  • Smoke Pipe
  • Stack Relay
  • Standard Thermostat – Limit $40
  • Transformer
  • Vent Alarm and Gauge Combination
  • Vent Alarm
  • Water Feeder (Non-Steam System)
  • Zone Valve (1)

Warm Air Heating System – $299

  • Air Filter
  • Blast Tube
  • Blower Belt
  • Burner Gaskets
  • Blower Motor (up to ¾ hp)
  • Blower and Shaft Assy
  • Burner Coupling
  • Burner Ignitors
  • Burner Fan
  • Burner Head
  • Burner Motor (up to 1/7 hp)
  • Cad Cell Assy
  • Cad Cell Assy
  • Combustion Chamber
  • Delay Oil Valve and Timer
  • Draft Regulator
  • Electrodes
  • Emergency/Service Switches
  • End Cone
  • Fan and Limit Switch
  • Firomatic Valve
  • Fuel Pump and Gasket
  • Nozzle
  • Nozzle Assy
  • Nozzle Line
  • Oil Filter (Cartridge)
  • Oil Filter (Complete)
  • Primary Control
  • Pump Strainer
  • Smoke Pipe
  • Stack Relay
  • Standard Thermostat – Limit $40
  • Transformer

Oil Fired Hot Water – $179

Propane or Natural Gas Fired Hot Water – $130

Note: Any discounts on parts and labor do not apply to system replacement.

Terms & Conditions

  1. This plan is available only to customers who purchase all of their heating oil from Spring Brook during the covered period and are in good credit standing with us. Failure to maintain either of these will automatically terminate the contract without a refund.
  2. We reserve the right to inspect your heating system before issuing the contract. If your equipment is improperly installed or not up to code, we cannot cover it. We will correct these defects, if you wish, at our usual rates.
  3. The term is for 12 months and will renew automatically.
  4. This plan does not cover others’ work, abnormal conditions such as, but not limited to, fire, power interruptions, acts of God, or other events beyond our control.
  5. This plan covers only residential systems with a maximum firing rate of three gallons per hour. Contracts are available for larger systems on an individual basis.
  6. This plan does not cover, and we are not responsible for any damage, including environmental, arising out of any leakage or spillage from oil lines, oil tanks, or any other part of your heating system.

High Praise From Our Clients